Safety and warning instructions
-
This device is intended for use in manicures only, in particular to reduce dust and particles during nail design. Do not use it for other purposes or activities.
-
Only connect the table to a suitable power source. Check the voltage specified in the operating instructions to avoid damaging the device.
Do not use the device near water or in humid environments to avoid the risk of electric shock.
Place the table on a stable, level surface. Ensure that the workplace is well lit and free of obstacles.
Keep children and unauthorised persons away from the manicure table, especially when using the suction.
The built-in extractor reduces dust and particles, but some exposure may still occur. Therefore, use a protective mask as needed to minimise the inhalation of fine dust.
The table and extractor are only suitable for fine nail dust and light particles. To avoid damage, do not place larger or heavier materials in the extractor.
Do not block the ventilation slots of the extractor. Blocked ventilation slots can cause overheating and malfunction.
Do not use the table if there are visible defects (e.g. damaged cables, cracks, defective extractor). Repairs should only be carried out by qualified personnel.
Avoid placing equipment that generates intense heat (e.g. UV lamps) directly on the table unless it is specifically designed for this purpose.
Replace or clean the filters of the extraction system regularly to ensure optimal performance and safe operation.
Clean the table with a soft, damp cloth after each working day. Do not use aggressive cleaning agents that could damage the surface.
Regularly remove dust and particles from the extraction system and clean the filters as recommended by the manufacturer. Use only replacement filters approved by the manufacturer.
Do not make any changes or modifications to the table or the suction system. This could impair safety and function.
Store the table in a dry and well-ventilated place when not in use.
Disposal instructions
The built-in extraction system contains electrical components and must not be disposed of in normal household waste. Dispose of the device in accordance with local regulations for electrical and electronic equipment (WEEE directive).
Contaminated filters that contain fine dust should be disposed of as residual waste or in accordance with local regulations. They must not be disposed of in the yellow sack or with recyclable waste.
